Step by Step updating for Openbox receivers
Parašytas: Ant Sau 29, 2008 10:03 pm
Step by Step updating for Openbox receivers
A couple of members have asked for a simple guide to updating their Openbox receivers, not supprising as it can be quite scarey the first time you try to do it. If you follow these simple steps one at a time you won't have any problems.
Before starting make sure that you have downloaded the Loader programme and have unzipped it and installed it on your worktop. You will also need the latest patch for your receiver.
Step 1 : Switch off the Openbox at the mains and connect it to your PC using a "null modem" cable.
Step 2 : Run the Loader programme and set the serial port to whichever serial port you use.
Step 4 : Now click the "File Tab" and load the Openbox update you downloaded.
Step 5 : Now click the "Update" tab and switch on the mains supply to the receiver.
You will now see 3 horizontal bars travelling from left to right, this will continue for a couple of minutes after which you will see "n" again moving left to right followed by "0" and lastly "8" DO NOT INTERRUPT THE PROCESS UNTILL YOU SEE "8" OK the update is over switch off the receiver, remove the cable and switch on the receiver again.
The main thing is once started do not interfere with the process YOU MUST WAIT FOR "8" to appear only then is the update over.
Follow these instructions and you won't go wrong, make sure that you use the correct file for your receiver.
Many thanks to Jimihendrix
A couple of members have asked for a simple guide to updating their Openbox receivers, not supprising as it can be quite scarey the first time you try to do it. If you follow these simple steps one at a time you won't have any problems.
Before starting make sure that you have downloaded the Loader programme and have unzipped it and installed it on your worktop. You will also need the latest patch for your receiver.
Step 1 : Switch off the Openbox at the mains and connect it to your PC using a "null modem" cable.
Step 2 : Run the Loader programme and set the serial port to whichever serial port you use.
Step 4 : Now click the "File Tab" and load the Openbox update you downloaded.
Step 5 : Now click the "Update" tab and switch on the mains supply to the receiver.
You will now see 3 horizontal bars travelling from left to right, this will continue for a couple of minutes after which you will see "n" again moving left to right followed by "0" and lastly "8" DO NOT INTERRUPT THE PROCESS UNTILL YOU SEE "8" OK the update is over switch off the receiver, remove the cable and switch on the receiver again.
The main thing is once started do not interfere with the process YOU MUST WAIT FOR "8" to appear only then is the update over.
Follow these instructions and you won't go wrong, make sure that you use the correct file for your receiver.
Many thanks to Jimihendrix